![]() First thing is make sure that the Digital TV Converter box has the analog pass through option. If all of the above is true than all you have to do is put your Digital to Analog TV Converter Box (with Analog Pass Through) in between your satellite receiver and the TV. If any of what I am assuming is not correct then my suggestion below may not work. I am also assuming that your TVs are receiving the satellite signal when they are tuned to either channel 3 or 4. ![]() I am also assuming that your satellite receivers are hooked up to the TV via a coax cable (Cable TV Type Cable). In other words the TV antenna analog signal is passing through the satellite receiver when it is turned off. I am also assuming that when the satellite receiver is not on that you can receive over the air channels on the TV when your RV's Video Switch Box is set to outside antenna. I am assuming that you have satellite receivers hooked up to each of your TVs in your RV. OK based on the information you have provided, I am going to have assume a few things. Can you explain how to hook up the digital converter box and where to plug in the satellite dish receiver?Įditor's Note: Removed e-mail address to protect Chet's privacy.ĪNSWER Greetings Chet thanks for submitting your question on our Ask An RV Question Page. ![]() This was very helpful however, it did not address my satellite dish receiver and how to deal with this during the installation. I was reading your article on installation of a digital converter box in an RV. Hooking Up Digital TV Converter Box In Conjunction With Satellite Receiver In An RV ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |